Month: September 2016

PCB Fabrication: Designing Approaches and Considerations

Designing and PCB fabrication is considered as an important part in the production of PCBs. This forms an important factor in electronic reliability and performance.

The productivity of your printed circuit board along with the serviceability and the assembly will also depend on the main design.


Your main layout should include all of the relevant details and aspects of your PCB design.On the other hand, the network may be produced at a ratio of 2:1, 1:1, or even at a 4:1 scale.

Experts recommend you to use a prepared 1:1 scale because this can help you measure the actual distance of one component of the board from the other parts.

In designing and constructing the PCB board itself, you have to closely follow a series of steps so you can be successful in your endeavor.

Initially, you will need to prepare all of the required circuit diagrams. Preparing these beforehand can help you prevent unnecessarily rushing through any of the steps involved.

This can also prevent slowing down the entire task of construction just because you do not have a systematic way of going through the entire process.

You also need to list out the components, sizes, and other specifications of the materials that you will use for the PCB fabrication.

This will make it easier for you to purchase what you need for the task. Also, this will help in significantly decreasing the chances of buying the wrong components for the PCB.

You may draft this on a graph sheet. After this, you should place all the pads and finish the thin tracks.

Place these on your mylor sheet and then on your graph sheet.

Using a knife, place the parts along with the screw holes. Fix all of the tracks.
You may then keep one component and consider this as the key.In PCB fabrication, you also need to convert your circuit diagram.

To do this, you should first cut the lines and mount them as soon as you have prepared all of them. You may then list down all of the components and specifications, including the thickness, diameters, code names, and lengths.

After this, keeping one of the components as the key aspect is highly advisable. Initially store the key component and the supporting tools along with them. All of the tracks should be set in straight lines. In between the ICs, you should not pass the signal lines.

PCB FabricationTo help you avoid some dislocations for the PCB, you need to mark the pin number of the IC on your layout. You should also keep in mind that you have to keep the length of your conductor as low as possible. Finally, position all of the diodes, resistors, and other types of components parallel to each other.

There are different types of layout approaches that you may utilize in PCB fabrication.
First, you should mark the connectors and the board outlines on a piece of paper. You may then sketch the component outlines using conductor patterns and connecting points.
You have to prepare the layout as initially seen from the side of the component. This will help you avoid any types of confusion in attaching the rest of the components. Your layout should be developed in the signal flow direction.

Among the components, you have to fill the larger ones first before you go for the space of the smaller ones. The output connections, rewiring input, and components should come near your connectors. All of the components that you will use should be placed in a way that will not require desoldering in the long run.